Corrugated cardboard is an economical way to make simple shapes and elegant form of the results with the ribbed surface of the board for the candle. Spray the board before paying to help the wax, the wax from sticking as it must prevent sets.You: lidbradawl clean plastic container (IL), water gap or double-faced corrugated silicone spray tapemold sealprimed wickwicking cups needlemeasuring (1 cup) waxstearin paraffin scale (10% of the amount of wax) double boilerwax spoonwax dyewooden 1 Thermometer The base currency of the instrument, and push the center of the lid with an awl, plastic (STL) to make a hole big enough to hold the wick .

Cut a rectangle of cardboard the size of the width of the candle height.2 appropriate. Spray the box with water or silicone oil to moisten. Roll into a cylinder and take sides with tape.3 double. Insert the central cylinder of cardboard, through the plastic cover. Seal the join with the seal of the mold – the form must be completely watertight.4. Cut a length of wick ignited. Connect one end with a wick pin, pushing the other end into the base of the mold. Leave the rest needle onto cardboard cylinder.

Seal the hole on the bottom with mold seal.5. Measure the required amount of paraffin and stearin. Dissolve stearic acid on top of a tank of water. Add color, to achieve the right color, stirring until well blended. Add the paraffin wax and heat until it is melted and reaches 180 F (82 C) Pour the wax into the mold, almost rim.6. Allow to cool candle. Top with melted wax around the wick when a good shape, as the wax shrinks. When the candle is completely set, remove the tap and die seal and remove the cardboard.

Trim excess wick.A range of light and heavy corrugated cardboard can be used to create a group of different sized candles with their backs. The natural color of the candles and cardboard and wrapped in a very contemporary addition, it would make a wonderful hand gift.For more worried about the cost of actual production of candle molds, make sure to click on the link below.