Material: Beeswax Candle scissors films WickInstructions: For this project we are using sheets of beeswax that come in a variety of colors. The candle wick we are using thick suitable medium for our candle dimensions. Sheet wax works best when you can in a hot environment, or the film crack.1 are: cutting you get your wax on a diagonal to a tapered effect, this song half way through our newspaper, and about 2 cm from a page. Use your scissors to cut along the edge. You can take your measurements vary only note, if you make more than a candle size.

2 the same: we hope the next cut off the wick too long. It must be flush against the bottom and hang about 1 inch in the top of the candle, remember to always cut the length later. Are you rolling your candle larger / wider end of the wick as the smallest is the largest end.3: Press the wax tightly around the wick to ensure this, that your candle will burn properly by providing an even source of wax for fuel .4: Apply strong pressure to roll the candle, and focus on your buttocks and hold so that you can up.

If you make a mistake just start unpacking and again.5: once to the end of your candle press force to stop the end of unrolling.Its candle now burning. You can decorate your candles with ribbons, raffia, and also marked by different denominations Profile wax.To bees Colored step by step video for free visit the project http://www.craftbits.com/viewProject.do?projectID=916 "This article was written by Shellie Wilson More Free candle making projects and instructions